Residential Safety Checklist

     1.   Outlets

Check for outlets that have loose-fitting plugs, which can overheat and lead to fire.  Replace any missing or broken wall plates.  Make sure there are safety covers on all unused outlets that are accessible to children.

     2.   Cords

Make sure cords are in good condition – not frayed or cracked. Make sure they are placed out of traffic areas.  Cords should never be nailed or stapled to the wall, baseboard or to another object. Do not place cords under carpets or rugs or rest any furniture on them.

     3.   Extension Cords

Check to see that cords are not overloaded.  Additionally, extension cords should only be used on a temporary basis; they are not intended as permanent household wiring.  Make sure extension cords have safety closures to help prevent young children from shock hazards and mouth burn injuries.

     4.   Plugs

Make sure your plugs fit your outlets.  Never remove the ground pin (the third prong) to make a three-prong plug fit a two-conductor outlet; this could lead to an electrical shock.  Never force a plug into an outlet if it does not fit.  Plugs should fit securely into outlets.  Avoid overloading outlets with too many appliances.

     5.   Ground Fault Circuit Interrupters (GFCIs)

GFCIs can help prevent electrocution.  They should be used in any area where water and electricity may come into contact.  When a GFCI senses current leakage in an electrical circuit, it assumes a ground fault has occurred.  It then interrupts power fast enough to help prevent serious injury from electrical shock.  Test GFCIs regularly according to the manufacturer’s instructions to make sure they are working properly.

     6.   Light Bulbs

Check the wattage of all bulbs in light fixtures to make sure they are the correct wattage for the size of the fixture.  Replace bulbs that have higher wattage than recommended; if you don’t know the correct wattage, check with the manufacturer of the fixture.  Make sure bulbs are screwed in securely; loose bulbs may overheat.

     7.   Circuit Breakers/Fuses

Circuit breakers and fuses should be the correct size current rating for their circuit.  If you do not know the correct size, have an electrician identify and label the size to be used.  Always replace a fuse with the same size fuse.

     8.   Water and Electricity Don’t Mix

Don’t leave plugged in appliances where they might come into contact with water.  If a plugged-in appliance falls into water, never reach in to pull it out – even if it’s turned off. First turn off the power source at the panel board and then unplug the appliance. If you have an appliance that has gotten wet, don’t use it until it has been checked by a qualified repair person.

     9.   Appliances

If an appliance repeatedly blows a fuse, trips a circuit breaker, or if it has given you a shock, unplug it and have it repaired or replaced.

     10.  Entertainment/Computer Equipment

Check to see that the equipment is in good condition and working properly. Look for cracks or damage in wiring, plugs and connectors.  Use a surge protector bearing the seal of a nationally recognized certification agency.

     11.  Outdoor Safety

Electric-powered mowers and other tools should not be used in the rain, on wet grass or in wet conditions.  Inspect power tools and electric lawn mowers before each use for frayed power cords, broken plugs, and cracked or broken housings.  If damaged, stop using it immediately. Repair it or replace it. Always use an extension cord marked for outdoor use and rated for the power needs of your tools.  Remember to unplug all portable power tools when not in use. Since metal ladders conduct electricity, watch out for overhead wires and power lines.

     12.  Lightning

During an electrical storm, do not use appliances such as hair dryers, toasters, and radios. Do not use telephones, except in an emergency. Do not take a bath or shower. Keep batteries on hand for flashlights and radios in case of a power outage and use surge protectors on electronic devices and appliances.

     13.  Space Heaters

Space heaters are meant to supply supplemental heat.  Keep them at least three feet away from any combustible materials such as bedding, clothing, draperies, furniture and rugs. Do not use in rooms where children are unsupervised and remember to turn the heaters off and unplug them when not in use.

     14.  Halogen Floor Lamps

Halogen floor lamps operate at much higher temperatures than a standard incandescent light bulb.  Never place a halogen floor lamp where it could come in contact with draperies, clothing or other combustible materials. Be sure to turn the lamp off whenever you leave the room for an extended period of time and never use torchiere lamps in children’s bedrooms or playrooms. Metal guards are now required for halogen torchiere lamps. To obtain a free wire guard, you may write to Dana Lighting, 55 Norfolk Avenue, Easton, Massachusetts 02375, Attn: Consumer Services.  Please include your name, address and number of guards needed. It will take approximately 8-10 weeks for delivery.

Taken from the National Electrical Safety Foundation, "May Is National Electrical Safety Month."

 

 

City and Borough of Sitka, Electric Department

105 Jarvis Street, Sitka, Alaska  99835
(907)747-4000, Emergency number (24 hours a day): 907-747-6634 Fax: 907-747-3208
Business Hours:  Monday through Friday, 8:00 a.m. to 5:00 p.m.